Any number of cameras can be
connected to Scorpion.
Before adding a camera, the camera driver must be installed. A number of drivers
are included on the Scorpion
CD.
Adding cameras to the default profile
involves these steps:
- Insert the Scorpion Vision Software CD-ROM in the CD-ROM drive.
- Select Drivers from the CD-ROM window to install selected
camera drivers.
- The DirectX8.1 driver or higher is required for camera operation under
Windows 2000.
- Verify that the driver is installed properly in the Device Manager
- Add the camera
- Add
the image and connect it to the camera. If you load images from
file, check here.
- Add
a system event for trigging the images - software trigging
User configurable tools perform the image analysis in Scorpion. You must
configure the tools to make Scorpion work for you.
In Scorpion, states are used to classify the result of an
inspection. In an identification system the states are typically a unit or
product. In assembly verification they can e.g. be pass, fail, no product or
cannot measure.
After defining the tools in the toolbox, you define the system's state.
It is derived from the tool results.
|
